Instructions on removing and reattaching wheels on the Go camper
Lug nut socket size is 3/4" or 19mm. To remove wheel, loosen all lug nuts first, then lower the swivel jack (on tongue) to its lowest position, drop the rear stabilizer jacks to their longest position, and raise the swivel jack until the wheels come off the ground. You can then remove the wheels.
To reattach the wheel, place wheel back into position on hub. Snug lug nuts then torque to 65-75ft/lbs. On the production floor, we use a 1/2" impact driver with a 65ft/lb torque stick. Be sure to tighten lug nuts in a star pattern as described below.
Disclaimer of Liability. SylvanSport assumes no liability whatsoever for any product damage or personal injury incurred while performing this work. The taking of proper safety precautions, including but not limited to the use of personal protective equipment, are wholly the responsibility of the person(s) performing the work contained herein.